BITBOX Complete Kit DeWalt 20 Volt Max Impact Driver Model #DCF787D1
$49.95$39.95
BITBOX Kit Complete for DeWalt 20 volt battery powered drills and impacts currently being sold by DeWalt 20Volt Left or Right Side Mounts. Please check below for restrictions on models.
BITBOX Kit contains
(1) BITBOX
(5) Steel Phillips #2 Screwdriver Bits
(3) Steel Flathead #8, #10 Screwdriver Bits
(3) Steel Square #2 Screwdriver Bits
(1) 7cm (2.75") Drive Guide Magnetic Extender
(1) Drill Snap Mount for DeWalt Model #(DCF787D1)
(1) Drill Snap Mount Screw
Important, Please read before you order.
Left or Right Side?
The BITBOX uses a Snap Mount to attach itself to your drill.
This mount attaches to the drill where the belt hanger mount is. This belt hanger mount is usually at the bottom of the drill, near the battery. Most drills have belt hanger mounts on both the left and right sides for left and right-handed users, but manufacturers only give you one belt hanger bracket. If your drill has this belt hanger mount, you will want to use the unused mount on the opposite side of your drill to attach your BITBOX.
If you do not use your belt hangers, you can attach the BITBOX on either side of your drill. Choose the side that feels most comfortable for you. The general rule is: if you use your drill in your right hand, get a right kit; if you use it in your left hand, get a left kit.
If you are using a belt hanger, then you will want to get a BITBOX kit on the opposite side of your drill’s belt hanger.
If you are ordering for someone else, ask them which hand they use their drill in or, more importantly, if they hang their drill on their belt, which side they hang their drill on. Whichever side they hang their drill on is the kit you want. If they hang their drill on the left, get a left kit, and if they hang their drill on the right, get a right kit.
We can not offer a free exchange for a different side mount after you purchase your BITBOX, so please make sure you know which side you want before you order. If you are not sure, you can always get one kit and get an additional single mount for the other side so you are covered no matter which side you decide to use.
Will BITBOX fit your drill?
This kit has been tested with these DeWalt Models.
If you have a question as to whether the BITBOX will fit on your drill please look at the picture of the belt hanger mount on a known model that works and make sure your drill matches that picture or contact us.
